Optical fiber interconnection between transmitter and receiver |
Number/type |
1 or 2 fiber optic |
Connectors |
2 LC connectors |
Operating distance |
|
Singlemode |
30 km (18.75 miles) with singlemode (SM) cables with a SM unit |
Multimode |
300 m (985') with 62.5 µm OM1 multimode (MM) cables with a MM unit 1 km (3280') with 50 µm OM2 multimode (MM) cables with a MM unit 2 km (6561') with 50 µm OM3/OM4 2000 MHz bandwidth laser optimized multimode cable with a MM unit |
NOTE |
Operating distance is approximate. These are typical maximum distances that may vary depending on factors such as fiber type, fiber bandwidth, connector splicing, losses, modal or chromatic dispersion, environmental factors, and kinks. | |
Nominal peak wavelength |
850 nm for MM units, 1310 nm for SM units |
Data rate |
4.25 Gbps |
Maximum pixel clock |
165 MHz |
Transmission power |
|
Singlemode |
-5 dBm, typical |
Multimode |
-5 dBm, typical |
Maximum receiver sensitivity |
|
Singlemode |
-18 dBm, typical |
Multimode |
-12 dBm, typical |
Optical loss budget |
|
Singlemode |
13 dB, maximum |
Multimode |
7 dB, maximum |
|
Video |
Digital |
|
Resolution range |
Up to 1920x1200 or 1080p @ 60 Hz, 8-bit color |
Formats |
RGB, YCbCr, and xvYCC digital video |
Standards |
DVI 1.0, HDMI compliant, HDCP 1.1, CEA-861E |
Analog |
|
Maximum resolution |
1600x1200 or 1080p @ 60 Hz, digitized pixel for pixel; higher resolutions up to 2048x1120, undersampled |
Signal type |
VGA-UXGA RGBHV, RGBS, component video |
Gain |
Unity |
Pixel data bit depth |
8 bits per channel, 3 channels (R, G, B; or YUV) |
|
Video input |
Digital |
|
Number/signal type |
2 HDMI, DVI, or DisplayPort |
Connectors |
2 female HDMI |
Equalization |
Up to 50' of cable |
Analog |
|
Number/signal type |
1 VGA-UXGA RGBHV, RGBS, RGsB, RsGsBs, component video (YUVp/HDTV) |
Connectors |
1 female 15-pin HD |
Nominal level |
1 Vp-p for Y of component video 0.7 Vp-p for RGB and for R-Y and B-Y of component video |
Minimum/maximum levels |
Analog: 0.3 V to 0.75 Vp-p with no offset, terminated |
Impedance |
75 ohms |
Horizontal frequency |
24 kHz to 100 kHz |
Vertical frequency |
40 Hz to 120 Hz |
Return loss |
<-40 dB @ 5 MHz |
|
Sync |
Input type |
RGBHV, RGBS, RGsB, RsGsBs, bi- level and tri-level component video (480p, 576p, 720p, 1080i, 1080p) |
Input level |
2.5 V to 5.0 Vp-p |
Input impedance |
10k ohms |
Polarity |
Positive or negative (follows input or can be set by user) |
|
Audio |
Gain |
|
Range |
Adjustable, -18 dB to +12 dB |
Default |
Unbalanced output: -6 dB |
Frequency response |
20 Hz to 20 kHz, ¡¾0.5 dB |
THD + Noise |
0.10% @ 1 kHz at nominal level |
S/N |
>80 dB at maximum output (unweighted) |
Audio bits per sample |
18 bits per channel, 2 channels (L, R) |
Sampling rate |
48 kHz |
|
Audio input |
Number/signal type |
1 unbalanced stereo |
Connectors |
(1) 3.5 mm mini stereo jack |
Impedance |
10k ohms unbalanced |
Nominal level |
-10 dBV (316 mVrms) |
Maximum level |
+7 dBV unbalanced |
NOTE |
0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu | |
|
Control/remote |
Serial control ports |
|
Control |
1 RS-232, 3.5 mm captive screw connector, 3 pole (rear panel) |
Pass-through |
1 RS-232, 3.5 mm captive screw connector, 5 pole (3 pins are used, "RS-232 Over Fiber", shared with alarm port) (rear panel) |
Baud rate and protocol |
|
Control |
9600 baud, 8 data bits, 1 stop bit, no parity |
Pass-through |
9600 to 115,200 baud |
Serial control pin configuration |
1 = Tx, 2 = Rx, 3 = GND |
USB control port |
1 front panel female mini USB B |
USB standards |
USB 2.0, low speed |
Contact closure |
(1) 3.5 mm captive screw connector, 4-pole |
Contact closure pin configuration |
1 = input 1, 2 = input 2, 3 = input 3, 4 = GND |
Program control |
Extron control/configuration program for Windows¢ç Extron Simple Instruction Set (SIS¢â) |
|
General |
Power supply |
External Input: 100-240 VAC, 50-60 Hz Output: 12 VDC, 1 A |
Power consumption |
|
Device |
TBD watts, 12 VDC |
Device and power supply |
TBD watts, 100-240 VAC, 50-60 Hz |
Temperature/humidity |
Storage: -40 to +158 ¡ÆF (-40 to +70 ¡ÆC) / 10% to 90%, noncondensing Operating: +32 to +122 ¡ÆF (0 to +50 ¡ÆC) / 10% to 90%, noncondensing |
Cooling |
Convection, vents on top and side panels |
Thermal dissipation |
|
Device |
X.X BTU/hr |
Device and power supply |
X.X BTU/hr |
Mounting |
|
Rack mount |
Yes, with optional rack shelf |
Furniture mount |
Yes, with optional under desk mounting kit |
Enclosure type |
Metal |
Enclosure dimensions |
1.7" H x 8.7" W x 6.0" D (half rack wide) (Depth excludes connectors.) |
Product weight |
1.0 lbs (0.3 kg) per unit |
Shipping weight |
3 lbs (2 kg) |
Vibration |
ISTA 1A in carton (International Safe Transit Association) |
Regulatory compliance |
|
Safety |
CE, c-UL, FDA Class 1, UL |
EMI/EMC |
CE, C-tick, FCC Class A, ICES, VCCI |
Environmental |
Complies with the appropriate requirements of RoHS, WEEE |
MTBF |
30,000 hours |
Warranty |
3 years parts and labor |