HOME > °¢Á¾ ¼¿·ºÅÍ/ºÐ¹è±â/º¯È¯ ÄÁ¹öÅÍ > DVI,HDMI ¼¿·ºÅÍ/ ºÐ¹è±â / ¸ÅÆ®¸¯½º > DVI ¸ÖƼÇ÷º¼­ [ ¸ÞÆ®¸¯½º ½ºÀ§ÃÄ ]
È®´ëº¸±â

[15778]EXTRON 8x4 DVI Matrix Switcher [ DXP 84 DVI Pro ] [°¡°Ý¹®ÀÇ]
½º   Æå : HDCP-Compliant DVI Matrix Switchers with EDID Minder¢ç
Á¦Á¶»ç : Extron [ÀͽºÆ®·Ð]
¼ö   ·® : °³
¿É   ¼Ç :
ÆǸŰ¡ : 0 ¿ø
Àû¸³±Ý : 0 ¿ø
100000ÀÌ»ó ±¸¸Å½Ã ¹«·á¹è¼Û ³³Ç°/³³±â °ßÀû¿äûÀº ÀüÈ­Áֽñ⠹ٶø´Ï´Ù.
Àå¹Ù±¸´Ï´ã±â ¹Ù·ÎÁÖ¹®Çϱâ
ÀÌÀüÈ­¸é
DXP 44 DVI Pro 4x4 DVI Matrix Switcher 60-875-01
DXP 48 DVI Pro 4x8 DVI Matrix Switcher 60-1009-01
DXP 84 DVI Pro 8x4 DVI Matrix Switcher 60-876-01
DXP 88 DVI Pro 8x8 DVI Matrix Switcher 60-877-01
DXP DVI Pro Series
NOTE *Appropriate DVI-D to HDMI cables or adapters are required for HDMI signal input/output.
Video
Routing
DXP 44 DVI PRO 4 x 4 matrix
DXP 48 DVI PRO 4 x 8 matrix
DXP 84 DVI PRO 8 x 4 matrix
DXP 88 DVI PRO 8 x 8 matrix
Signal type Single-link DVI digital video signals are supported
Digital video RGB digital video (DVI and HDMI standards) or Y, Cr, Cb digital component video (HDMI), actively buffered (supports all single-link DVI and HDMI (if using an optional adapter) standards from 640x480 @ 60 Hz to 1600x1200 @ 60 Hz computer video)
NOTE The DXP DVI Series switchers are compatible with HDMI 1.3.
Digital audio Supports HDMI audio (if using an HDMI to DVI adapter) transmitted through the RGB and Y, Cr, Cb lines, actively buffered.
EDID and DDC Supports Extended Display Identification Data (EDID) and Display Data Channel (DDC) data using DVI and HDMI standards. EDID and DDC signals are actively buffered.
HDCP Compliant with High-bandwidth Digital Content Protection (HDCP) using DVI and HDMI 1.3 standards
HPD Supports hot plug detection (HPD) of display as a pass-through signal.
Gain Unity
Resolution range Up to 1080p (HDTV) or 1920x1200 (the highest resolution of the single-link DVI standard) @ 60 Hz
Maximum data rate 6.75 Gbps (2.25 Gbps per color)
Maximum pixel clock 225 MHz
Standards DVI 1.0, HDMI 1.3
Video input
Number/signal type 4 or 8 (depending on model) digital RGB (TMDS) single-link DVI-D (or HDMI*)
Connectors 4 or 8 female DVI-I (digital only)
Nominal level
Digital video 1.2 Vp-p
DDC (Display Data Channel) 5.0 Vp-p (TTL)
Minimum/maximum level 0.5 V to 1.0 Vp-p with no offset
Impedance 100 ohms
Return loss <-15 dB @ 1 MHz to 1.5 GHz
TDR rise time (10%-90%) 75 ps
Equalization Automatic
Input cable length >100' (30 m) at 1920x1200 @ 48, 50, or 60 Hz; or 1080p; 8 bit color
NOTE The transmission distance varies depending on the signal resolution and on the type of cable, graphic card, and display used in the system.
Video output
Number/signal type 4 or 8 (depending on model) digital RGB
Connectors 4 or 8 female DVI-I
Nominal level 1.2 Vp-p
Minimum/maximum level(s) 0.5 V to 1.0 Vp-p with no offset (follows input)
Impedance 100 ohms
Return loss <-15 dB @ 1 MHz to 1.5 GHz
DC offset ¡¾500 mV maximum with input at 0 offset
Rise and fall time (20-80%) 0.6 ns
Re-clocking Automatic
Peripheral device power 250 mA per output
Control/remote — switcher
Serial control port (1) RS-232, 9-pin female D connector
(1) RS-232, front panel 2.5 mm mini stereo jack
Baud rate and protocol 9600 to 115200 baud, 9600 baud (default), 8 data bits, 1 stop bit, no parity
Serial control pin configurations
9-pin D connector 2 = Tx, 3 = Rx, 5 = GND
Mini stereo jack Tip = Tx, ring = Rx, sleeve = GND
Ethernet control port (1) RJ-45 female connector
Ethernet data rate 10/100Base-T, half/full duplex with autodetect
Ethernet protocol ARP, ICMP (ping), IP, TCP, DHCP, HTTP, Telnet
Default settings Link speed and duplex level = autodetected
IP address = 192.168.254.254
Subnet mask = 255.255.0.0
Gateway = 0.0.0.0
DHCP = off
Program control Extron control/configuration program for Windows¢ç
Extron Simple Instruction Set (SIS¢â)
Microsoft¢ç Internet Explorer¢ç ver. 6 or higher, Telnet
General
Power 100 VAC to 240 VAC, 50-60 Hz, internal; fully loaded 8 x 8 unit
115 VAC, 60 Hz 48 watts
240 VAC, 50 Hz 48 watts
Temperature/humidity Storage: -40 to +158 ¡ÆF (-40 to +70 ¡ÆC) / 10% to 90%, noncondensing
Operating: +32 to +122 ¡ÆF (0 to +50 ¡ÆC) / 10% to 90%, noncondensing
Cooling Fan, air flows right to left (as viewed from front)
Thermal dissipation, full load
115 VAC, 60 Hz 129.7 BTU/hr
240 VAC, 50 Hz 126.3 BTU/hr
Mounting
Rack mount Yes, 2U high
Enclosure type Metal
Enclosure dimensions 3.5" H x 17.5" W x 12.0" D (2U high, full rack wide)
(8.9 cm H x 44.4 cm W x 30.5 cm D)
(Depth excludes connectors. Width excludes integrated rack ears.)
Product weight 10.0 lbs (4.5 kg)
Shipping weight 15 lbs (7 kg)
Vibration ISTA 1A in carton (International Safe Transit Association)
Regulatory compliance
Safety CE, c-UL, UL
Compliances CE, C-tick, FCC Class A, ICES, VCCI
MTBF 30,000 hours
Warranty 3 years parts and labor
Panel Drawing
Product Diagram